To turn on the Motion Sensor you should remove the back panel, open the battery cover and pull out the insulating strip. After that, the LED on its body will blink. The Sensor is considered to be switched on.
The Smoke Sensor detects visible smoke particles at the flameless stage and transmits a corresponding alarm to the Perenio® Control Gateway, as well as emits a loud signal.
To check operation of the Smoke Sensor, it is necessary to press the Test Button in order for the signal to be emitted.
To check operation of the Smoke Sensor, it is necessary to press the Test Button in order for the signal to be emitted.
To switch on the Sensor, it is necessary to remove the back panel and pull out the battery insulating strip. After that, the LED under its casing will blink.
You should close contacts at the casing bottom, e.g. by touching both detectors with your fingers. If you hear a sound signal it means that the Leak Sensor is ready for operation. For details, see the manual available for downloading on our website.
After the device is powered on, the power LED will light up, and a corresponding access point of this CG (containing its ID) will be displayed in the list of available networks in Wi-Fi Settings of your smartphone.
- All categories
- Glossary
- Apple HomeKit
- Amazon
- Voice Control Setup
- Power Link
- Red Atom
- Portable UV Lamp Mini Indigo
- Smart UV Disinfection Kit UV Lightsaber
- Power Link Wi-Fi
- Google Assistant
- Notifications
- Control Gateway
- Indoor Motor Camera
- Indoor Fixed Camera
- Smoke Sensor
- Leak Sensor
- Door & Window Sensor
- Motion Sensor
- Smart Security Kit
- Powering on
- Installation
- Connection to the Mobile App
- Specification